You can also put cards on the back side of the page, so it can hold approximately 180 cards, but is expandable to hold many many more cards if you purchase extra pages (Can hold up to a maximum of 360 cards if you add 10 extra pages)
Brand: The Pokemon Company
Theres nothing wrong with having a set filled to the brim with cool cards for Commander players, but it always feels a touch out of place in a Standard release
There may be some decks that value this very highly, but the floor is low
Mega Blaziken's high HP comes in useful in this regard, with its bulkiness allowing it to outlast the opposition in most situations
The shafts I used were made for these O-rings (on amazon.ca): uxcell Silicone O-Ring, 18mm OD, 12mm ID, 3mm Width, VMQ Seal Rings Gasket, White, Pack of 10 MTG_Shuffler_Shaft_v2 are the re-designed shafts with grooves to hold o-rings (the amazon link above) - if you print these, then don't print the shafts in the card.shuffler.v3mrb-parts.3mf file (right click on them and uncheck printable) nor the card.shuffler.shaft.rubber-band.3mf file if you're using small rubber bands, print the card.shuffler.shaft.rubber-band.3mf file (resized from the previous model) lastly, the shafts in the card.shuffler.v3mrb-parts.3mf don't have a groove, and could be plasti-dipped or used with U-shaped seals that wrap around the disc I was more comfortable in Fusion360, so I used it for the redesigned shaft (o-ring variant)
